Hub Phone 2.1 Time and date not updating.

[LavaGiant]

I have a HH2A with PSIDoc mods running VoIP to Sipgate with a registered Hub Phone 2.1.

The time and date will not update from the HH2A even though its correctly getting time from NTP servers.

The software on the HP2.1 is 1692.7, the software on the HH2A is Version 8.1.H.J (Type A).

The phone is registered to the HH2A without problems and all other functions appear well, calls on SIP and PSTN fine, apart from CLI only displays after call is answered (might be a feature).

This was the case before mods applied on standard BT firmware, I wrongly assumed it may pick up date and time info from an incoming call like some of my handsets but never tried it before applying the mods.

Can someone help with this or is this common, its not that important just so irritating!

[RobinGill]

Same problem here.

Can't say if it ever did work before it was hacked as the hub wasn't connected to the net, but would be greatful for any ideas better than mine (I'm going to power cycle at midnight to get it showing the correct time) which will work but if the power goes on the phone it will need to be done again.