WPS (access Point with Unlocked HH 2.0b) How to

[metalonhead]

A happy new year to all,
I have used your great tutorial to unlock the BT HH2.0b however i want to set it up as a wireless access point which will receive a wireless signal from another router (taking through ethernet port is not possible). I found a method of doing this with HH2.0a with telnet however i have not been able to find the same for 2.0b. Can somebody guide me on how to go about this.

Regards to all

[TheoKlink]

Ditto to metalonhead. There is ample on the HH2a but no ideas on HH2b. Perhaps interest has shifted to HH3?. I found nothing in the "conf print /" output that could give a clue. Anyway, it is fun rummaging around inside.

[Technodevotee]

This is something I wanted to try and I did some preliminary research but have not got round to trying it as there are too many other things I want to do.

The open_rg configuration manual 23 describes how to switch the WLAN Access Point to repeater mode in section 23.13.1

/dev/<name>/wlan/operation_mode

configuration of the repeater is covered in section 23.13.3

and then in section 23.14 there is

dev/<name>/wl_ap/wl_mode_ap


I once reconfigured the LAN to obtain a DHCP lease from my server by changing settings such as

/dev/<name>/is_sync

as decribed in the network connections, general section

I would assume that setting the wlan device to obtain a DHCP lease from the Access Point should be possible using the same method.

technodevotee