Dim lights and no CFE=BAD HELP!

[thatguy1982]

hello. i have done the jtagless method of installing st790 firmware that involves replacing the CFE. i have managed to do this sucessfully on first attempt with my hub v1. however i just tried it with the homehub V1.5, and at the erasing CFE stage, it booted me out. i know how to wire a jtag and im sure i can find the pin assignments myself, but the problem is what do i do now.. i have no CFE and no backup CFE (it never wrote to the usb for some reason, did with the hub v1).

can someone help me out here with a new CFE and a step by step of what do command wise with the debrick utility, would be helpfull and you will be saving a hub from the bin

[thatguy1982]

Quick update.. i have installed a JTAG and it is all setup correctley. restored the CFE from my homehub V1, that did back up correctly. when rebooted i have all 4 lights on and flashing green and 2 dim red. i am hoping it is now in BOOTP mode and waiting for a update. il have a cigarette and dig out a ethernet cable grab 6.2.2.6 and edit this post with results

EDIT: Im Back.. its alive. flash failed aparently but it came back up on 6.2.2.6.
only trouble is it now has the old hubs identity and no power light on. also 3 dimly glowing red lights on phone upgrading and broadband as well as the totally normal screwed up lights lol.

Also i was wondering if anyone has come up with a way to edit the CFE yet, and add back the original infomation. i was reading somthing about PSidoc and someone else working out how the checksums are calculated, but i think thas only half the battle.