connect two v2a hubs

[screamin]

As the title says, I have two v2a home hubs using one wired to pc. The signal for WiFi is really poor in other areas of the house. So having read the guides, I'm looking for your assistance before I proceed. Is it possible to use one as a repeater to boost the signal around the house. What's the easiest way of doing this? I'm assuming they don't need to be hardwired? Cheers for any help in advance

[screamin]

i think i have it figured out will request help if i need it, managed to flash one hub next one done later.
Very useful here lol

[screamin]

Ok some help please??
I have followed all the instructions, flashed both hubs, made sure through telnet both hubs had each others bssid and all saved.
However using my phones wifi to try and connect to the hub which is being used as a repeater im having no joy, it keeps saying trying to find ip, then just disconnects and connects to the 1st hub.
I tried also following the guide http://www.psidoc.com/showthread.php...light=repeater here but it just says unable to add WDS AP, it is already present.
Forgive one so stupid but whats happened??
It appears the hub being used as a repeater isnt repeating?
Thanks

[screamin]

Ten to 1 in the morning and after a lot of playing around i got it working, no disrespect meant at all but needed a lot of playing around with looking in different posts to try and get it to work so tomorrow im going to post a step by step of connecting my hubs together as a bridge and hopefully make it clearer for everyone.
gnite all and thanks for helping me solve poor wifi in the house

[jeffdat]

hi, where else can you find the mac address of the hub if you cant see it anywhere? i dont have the original package and the stickers have not got them either, help pls i need connect two v2a hubs together.
thanks